Good morning,
I can’t figure out how to send tcp messages to an mrx7-d matrix. I think the syntax is slightly different than other Yamaha Mixers. Plus I think remote targets need to be identified in MRX. I have read the manual but I am struggling a bit. Does anyone have any experience?
At one point, I was looking at creating a module, but it’s far too complex.
Might be better to look at using Provisionaire for control?
I assume you have the documentation? If not, here it is:
Thank you for your reply. Yes, I will also have Provisionaire on an iPad, but I need to change only one fader level (master of the room) using a command. It’s a complex project, there is a sort of virtual assistant (with speech to text) that supposed to change audio volume. It also manage video contents and lights and it will have generative Ai.
Thank you for the document, my tests of these days are based on it. Can you only confirm that target of remote commands are the same configured for Provisionaire purposes (Remote List)? Do you know which information of this list I should put in command line (number, or something different)?
I’m sorry, I don’t really know as I haven’t really looked into it very much.
If this is a project that you have a budget to create a module or solution, feel free to DM me and I’d be happy to discuss it.
Hi Andy, this week by doing some more tests I was able to resolve my doubts. Let me know if you need any information. Regards